The way to Fill the visible difference Involving the Basement Foundation

Protecting a basement foundation from water damage and cracking is crucial. A space between a basement foundation plus a sidewalk leaves both structures susceptible to severe water damage and mold. Filling the area with semi-flexible, rot-resistant material blocks moisture while allowing the structures to shift without cracking. Do-it-yourself people who have no experience can complete this project in a afternoon along with a full day for that caulk to set.

Get rid of the visible difference involving the foundation and sidewalk which has a long wire brush. Chip off any hard debris or caulk stuck about the sides with a hammer as well as a chisel. Appraise the width in the gap with measuring tape. If it’s wider than 1/2 inch, you’ll must fill in the space with an expansion joint like foam backer rod. If it’s less than a 1/2 inch wide, you'll be able to complete Expanding Foam Tape. Convey a strip of foam backer rod on top of the sidewalk parallel on the gap. Use a utility knife to slice the rod to fit along the gap. In the event the rod is not of sufficient length, cut another piece to adjust to the rest of the space. Lay the foam backer rod over the gap and push it down along with your hands. If you’re using two lengths of rod, push these down hence the ends are flush. Use the blunt end of an putty knife going to the rod into the base of the gap. Load silicone latex caulk in a caulk gun and snip off of the end with scissors. Fill the residual gap together with the caulk until its level with the sidewalk. Hold a putty knife level with one for reds in the pavement and the other on the caulk. Run the knife slowly down the whole gap to take out excess also to make certain that caulk is level.