The best way to Fill the space Between the Basement Foundation

Protecting a basement foundation from water damage and mold and cracking is important. A spot from a basement foundation along with a sidewalk leaves both structures prone to severe inundating. Filling the room with semi-flexible, rot-resistant material blocks moisture while allowing the structures to shift without cracking. Do-it-yourself people who have little if any experience can complete this project in a afternoon along with a full day for that caulk to put.

Cleanse the gap involving the foundation and sidewalk which has a long wire brush. Chip off any hard debris or caulk stuck about the sides having a hammer and a chisel. Appraise the width in the gap with tape measure. If it’s wider than 1/2 inch, you’ll need to fill out a real difference with an expansion joint like foam backer rod. If it’s only a 1/2 inch wide, it is possible to add Expanding Foam Tape. Place a strip of froth backer rod on top of the sidewalk parallel on the gap. Make use of a utility knife to reduce the rod to adjust to the duration of a real difference. When the rod is not long enough, cut another piece to suit the remainder space. Lay the foam backer rod into the gap and push it down with your hands. If you’re using two lengths of rod, push these down and so the ends are flush. Use the blunt end of the putty knife to hit the rod down to the bottom of the visible difference. Load silicone latex caulk into a caulk gun and snip from the end with scissors. Fill the remainder gap together with the caulk until its level with all the sidewalk. Hold a putty knife level with one side in the pavement and the other within the caulk. Run the knife slowly down the length of the gap to take out excess and also to be sure that the caulk is level.