How to Fill a real difference Involving the Basement Foundation

Protecting a basement foundation from water damage and cracking is vital. A space from the basement foundation and a sidewalk leaves both structures prone to severe inundating. Filling the area with semi-flexible, rot-resistant material blocks moisture while allowing the structures to shift without cracking. Do-it-yourself people who have minimum experience can complete this project in a afternoon along with a full day for the caulk to create.

Get rid of a real difference between the foundation and sidewalk using a long wire brush. Chip off any hard debris or caulk stuck for the sides with a hammer along with a chisel. Look at the width with the gap with measuring tape. If it’s wider than 1/2 inch, you’ll must fill out the visible difference with an expansion joint like foam backer rod. If it’s under a 1/2 inch wide, it is possible to fill out Compriband 600. Convey a strip of foam backer rod over the sidewalk parallel on the gap. Utilize a utility knife to slice the rod to fit the size of the space. In the event the rod is not good enough, cut another piece to suit the remaining space. Lay the foam backer rod over the gap and push it down along with your hands. If you’re using two lengths of rod, push these down therefore the ends are flush. Utilize blunt end of a putty knife heading to the rod right down to the foot of the gap. Load silicone latex caulk in to a caulk gun and snip over end with scissors. Fill the rest of the gap with the caulk until its level with all the sidewalk. Hold a putty knife level with either side in the pavement and yet another on the caulk. Run the knife slowly on the length of the gap to remove excess and to make sure that the caulk is level.