The best way to Fill the visible difference Between your Basement Foundation

Protecting a basement foundation from water damage and mold and cracking is crucial. A spot between a basement foundation and a sidewalk leaves both structures vulnerable to severe inundating. Filling the area with semi-flexible, rot-resistant material blocks moisture while allowing the structures to shift without cracking. Do-it-yourself people who have little or no experience can complete this project in an afternoon along with a full day for your caulk setting.

Get rid of the visible difference between your foundation and sidewalk having a long wire brush. Chip off any hard debris or caulk stuck for the sides using a hammer as well as a chisel. Measure the width of the gap with tape measure. If it’s wider than 1/2 inch, you’ll should add the space with an expansion joint like foam backer rod. If it’s just one 1/2 inch wide, you can fill out EXP6 Expanding Foam Tape. Place a strip of foam backer rod in the sidewalk parallel towards the gap. Work with a utility knife to cut the rod to match the duration of the gap. In the event the rod is just not for a specified duration, cut another piece to suit the rest of the space. Lay the froth backer rod over the gap and push it down together with your hands. If you’re using two lengths of rod, push these down hence the ends are flush. Make use of the blunt end of an putty knife to hit the rod as a result of the bottom of a real difference. Load silicone latex caulk in a caulk gun and snip from the end with scissors. Fill the rest of the gap with all the caulk until its level using the sidewalk. Hold a putty knife level with the whites within the pavement and the other on the caulk. Run the knife slowly down the length of the gap to eliminate excess also to be sure that the caulk is level.